Request for quotation

Contact us or submit a request for tender

Leave a request for quotation

Use the form below to give the measures, material and other essential information of the product. Usually the information provided here is enough to make a tender. If you wish, you can attach a picture but it is not necessary at this stage. It is possible to send more precise pictures or sketches to us by fax, e-mail or mail later. 



Number of pieces required
We can make a tender with up to four series sizes but one series size is sufficient.


Examples
Below you can see some examples and recommendation for measurement. You can tick the form(s) closest to your object if desired:


1. Easy form.

2. Inner length easy if short (approx. 8 mm). More difficult if longer.

3. Outer angles are sharp. Inner corners R > 3 mm.

4. The form is not complicated but it requires two different tools and two work phases.

5. The bend at the outer edge rounds off the sharp edge and strengthens it.

6. The form requires two different tools and two work phases.

7. Easy if the vertex angle is > 60 degrees. A sharper angle is also possible.

8. Bending the smaller end requires a separate tool and an extra work phase.

9. Easy if the height is less than half of the diameter.

10. The form requires a demountable mould. The tool and parts needed are expensive.

11. A hemisphere is relatively easy to make. Stainless steel and brass can be problematic materials.

12. A spherical cap is easier to make than a hemisphere. The brim can be strengthened with a bend or a flange.

13. The trumpet shape of the lower half is easy. The long upper half is more difficult.

14. The form is difficult. At the top there should be an approx. 25 mm long straight part.

15. Cone ok if the cylinder is < 8 mm.
Description of the object(s)
Here you can give a more precise description of the form and measurements of your object.
We will contact you if we need any more information for making a tender.

E.g. “a cone whose height is 300 mm. The diameter of the larger end is 450 mm. At the larger end there is a 300 mm wide flange like part. The smaller end of the cone is 100 mm. The end is otherwise solid but in the middle there is a hole whose diameter is 30 mm.”

  

Painosorvaamo Painopojat Oy
Metsovaarantie 1
31720 Urjalankylä, URJALA

Tel: +358 3 546 3450

E-mail: 

MENU